LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 516 (Lighting Systems - Exterior) >> Lamp Bar >> Installation >> Lamp

Lamp Bar: Installation: Lamp

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the lamp and bracket unit onto the light bar reinforcement. See Figure.
    NOTE: There is a hook on the forward edge of the lamp bracket that must be secured under a tab that is integral to the reinforcement. The rear of the lamp must be lifted upward by the lamp socket/connector in order to engage the hook under the tab.
  2. Lift the lamp socket/connector on the rear of the lamp upward far enough to engage the hook on the front edge of the lamp bracket under the integral tab of the reinforcement.
  3. Slide the lamp and bracket forward and seat.
  4. Install and tighten the two screws that secure the rear of the lamp bracket to the reinforcement. See Figure. Tighten the screws to 2 N.m (17 in. lbs.).
  5. Reconnect the light bar wire harness connector to the socket on the back of the lamp.
  6. Reconnect the battery negative cable.
  7. Confirm proper lamp alignment. (Refer to ELECTRICAL/LAMPS/LIGHTING - EXTERIOR/LIGHT BAR LAMP - ADJUSTMENTS) .
  8. Reinstall the cover over the light bar lamps and reinforcement. (Refer to ELECTRICAL/LAMPS/LIGHTING - EXTERIOR/LIGHT BAR LAMP COVER - INSTALLATION) .
scientia non olet · About LEMON Manuals