Light Bar Lamp Adjustment

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Only the vertical aim of the light bar lamp beams is adjustable.

Rock the vehicle from side-to-side three times to allow the suspension to stabilize, then jounce the front suspension three times by pushing downward on the front bumper and releasing.
Turn the adjusting screw on the back of the light bar lamp until the beam intensity pattern is centered on the up-and-down (vertical) adjustment reference tape on the alignment screen. See Fig 1.

Fig 1: Light Bar Lamp Adjustment Screw
Courtesy of DAIMLERCHRYSLER CORP.

1 - LIGHT BAR LAMP (REAR)

2 - ADJUSTMENT SCREW
Repeat the adjustment procedure for each lamp as required.