Headlamp Low Beam Relay: Description
WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
| 30 - COMMON FEED | |
| 85 - COIL GROUND | |
| 86 - COIL BATTERY | |
| 87 - NORMALLY OPEN | |
| 87A - NORMALLY CLOSED |
The headlamp low beam relay is a conventional International Standards Organization (ISO) micro relay. See Fig 1. Relays conforming to the ISO specifications have common physical dimensions, current capacities, terminal patterns, and terminal functions. This relay is contained within a small, rectangular, molded plastic housing and is connected to all of the required inputs and outputs through five integral male spade-type terminals that extend from the relay base plate.
The headlamp low beam relay is located in the Junction Block (JB) on the driver side instrument panel end bracket. The headlamp low beam relay cannot be adjusted or repaired and, if faulty or damaged, it must be replaced with a new unit.