Bulb - Fascia Mounted

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Do not contaminate the bulb glass by touching it with your fingers or by allowing it to contact other oily surfaces. Shortened bulb life will result.

Disconnect and isolate the battery negative cable.
Remove the three screws that secure the front fog lamp bezel and lens to the back of the lamp housing. See Fig 1.

Fig 1: Fog Lamp Lens/Bezel Screws
Courtesy of DAIMLERCHRYSLER CORP.

1 - HOUSING

2 - SCREW (3)

Pull the bezel and lens away from the front of the lamp housing far enough to access and disconnect the fog lamp wiring connector from the bulb pigtail wire. See Fig 2.

Fig 2: Fog Lamp Bulb Connections

Courtesy of DAIMLERCHRYSLER CORP.

1 - BEZEL

2 - CONNECTOR

3 - GROUND TERMINAL

4 - BULB

5 - LENS REFLECTOR

Pinch together the two hooked ends of the bulb retainer clip and disengage them from the slots in the mounting flange on the back of the lens reflector. See Fig 3.

Fig 3: Fog Lamp Bulb Retainer

Courtesy of DAIMLERCHRYSLER CORP.

1 - BULB FLANGE

2 - RETAINER CLIP

3 - SLOT (2)

4 - MOUNTING FLANGE

Pivot the retainer clip up off of the bulb flange and out of the way.
Pull the bulb straight out of the mounting flange on the back of the lens reflector.