LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 516 (Lighting Systems - Exterior) >> Front Fog Lamp >> Installation >> Lamp - Grille Mounted

Lamp - Grille Mounted

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the front fog lamp to the seat in the grille opening reinforcement. See Figure.
  2. Reconnect the wire harness connector to the bulb socket on the back of the lamp housing.
  3. Engage the pivot pin on either side of the lamp into its receptacle in the stanchion within the lamp seat of the grille opening reinforcement.
  4. Insert a trim stick or another suitable wide flat-bladed tool, between the opposite side of the lamp and the side of the lamp seat.
  5. Carefully pry between the side of the lamp and the seat far enough for the loose pivot pin to be snapped into place within its stanchion.
  6. Install and tighten the screw that secures the fog lamp adjuster bracket to the grille opening reinforcement. Tighten the screw to 3 N.m (30 in. lbs.).
  7. Reinstall the grille panel onto the front of the grille opening reinforcement. (Refer to BODY/EXTERIOR/GRILLE - INSTALLATION) .
  8. Reconnect the battery negative cable.
  9. Confirm proper front fog lamp alignment. (Refer to ADJUSTMENTS ).
scientia non olet · About LEMON Manuals