Bulb - Grille Mounted

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the lamp, the socket and/or the lamp wiring.

CAUTION: Do not contaminate the bulb glass by touching it with your fingers or by allowing it to contact other oily surfaces. Shortened bulb life will result.

Align the base of the bulb with the front fog lamp socket. See Figure.
Push the bulb straight into the socket until the base is firmly seated.
Align the socket and bulb with the keyed opening on the back of the front fog lamp housing.
Insert the socket and bulb into the housing until the socket is firmly seated.
Rotate the socket clockwise about 30 degrees to lock it into place. The socket connector receptacle should be pointed horizontally.
Reinstall the fog lamp into the grille opening reinforcement. (Refer to ELECTRICAL/LAMPS/LIGHTING - EXTERIOR/FRONT FOG LAMP - INSTALLATION) .
Reconnect the battery negative cable.