Bulb - Fascia Mounted
WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the lamp, the socket and/or the lamp wiring.
CAUTION:
Do not contaminate the bulb glass by touching it with your fingers or by allowing it to contact other oily surfaces. Shortened bulb life will result.
- Align the fog lamp bulb flange with the mounting flange on the back of the lens reflector. See Figure.
- Insert the bulb straight into the opening in the mounting flange until the bulb flange is firmly seated.
- Pivot the bulb retainer clip up and over the bulb flange.
- Pinch together the two hooked ends of the retainer clip and engage them into the slots in the mounting flange to lock the bulb into place.
- Reconnect the bulb pigtail wire to the fog lamp wiring connector. See Figure.
- Align and install the lens and bezel into the front fog lamp housing. Be certain not to pinch the lamp wiring between the housing and the bezel.
- Install and tighten the three screws that secure the bezel and lens to the back of the lamp housing. See Figure. Tighten the screws to 2 N.m (17 in. lbs.).
- Reconnect the battery negative cable.