Line Pressure (LP) Sensor: Removal

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Locating Input Speed, Output Speed and Line Pressure Sensors

Courtesy of DAIMLERCHRYSLER CORP.

1 - OUTPUT SPEED SENSOR

2 - LINE PRESSURE SENSOR

3 - INPUT SPEED SENSOR

Raise vehicle.
Place a suitable fluid catch pan under the transmission.
Remove the wiring connector from the line pressure sensor (2). See Fig 1
Remove the bolt holding the line pressure sensor (2) to the transmission case.
Remove the line pressure sensor (2) from the transmission case.