Input Speed Sensor: Installation

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Locating Input Speed, Output Speed and Line Pressure Sensors

Courtesy of DAIMLERCHRYSLER CORP.

1 - OUTPUT SPEED SENSOR

2 - LINE PRESSURE SENSOR

3 - INPUT SPEED SENSOR

Install the input speed sensor (3) into the transmission case. See Fig 1.
Install the bolt to hold the input speed sensor (3) into the transmission case. Tighten the bolt to 11.9 N.m (105 in.lbs.).
Install the wiring connector onto the input speed sensor.
Verify the transmission fluid level. Add fluid as necessary.
Lower vehicle.