LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 514 (Diagnosis & Overhaul - NV242 Transfer Case) >> Shift Lever >> Installation

Shift Lever: Installation

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Route the shift cable through the opening in the floor pan.
  2. Position the shift mechanism over the shifter retaining studs on the floor pan.
  3. Install the nuts to hold the shifter mechanism to the floor pan. Tighten the nuts to 11.86 N.m (105 in. lbs.).
  4. Install any floor console components previously removed. (Refer to BODY/INTERIOR/FLOOR CONSOLE - INSTALLATION)
  5. Verify that the floor shifter is in the 4L position.
  6. Raise vehicle.
  7. Route the shift cable through the opening in the shift cable support bracket.
  8. Install the cable and a new spring clip into the slot in the support bracket.
  9. Install any additional routing clips on the shift cable.
  10. Verify that the transfer case is in the 4L position. The 4L position for the transfer case is with the manual lever to the full rearward position.
  11. Attach the shift cable to the transfer case manual lever.
  12. Lower vehicle and check for proper transfer case shifter operation.
scientia non olet · About LEMON Manuals