LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 511 (Diagnosis & Overhaul - 42RLE Automatic Transmission) >> Output Speed Sensor >> Removal

Output Speed Sensor: Removal

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Locating Input Speed, Output Speed and Transmission Range Sensors
GC0009445Courtesy of DAIMLERCHRYSLER CORP.
1 - INPUT SPEED SENSOR
2 - OUTPUT SPEED SENSOR
3 - TRANSMISSION RANGE SENSOR
  1. Raise vehicle.
  2. Place a suitable fluid catch pan under the transmission.
  3. Remove the wiring connector from the output speed sensor (2). See Fig 1.
    NOTE: The speed sensor bolt has a sealing patch applied from the factory. Be sure to reuse the same bolt.
  4. Remove the bolt holding the output speed sensor to the transmission case.
  5. Remove the output speed sensor (2) from the transmission case.
scientia non olet · About LEMON Manuals