Input Speed Sensor: Installation

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Locating Input Speed, Output Speed and Transmission Range Sensors

Courtesy of DAIMLERCHRYSLER CORP.

1 - INPUT SPEED SENSOR

2 - OUTPUT SPEED SENSOR

3 - TRANSMISSION RANGE SENSOR

Install the input speed sensor (1). See Fig 1into the transmission case.
NOTE: Before installing the speed sensor bolt, it will be necessary to replenish the sealing patch on the bolt using Mopar® Lock & Seal Adhesive.
Install the bolt to hold the input speed sensor into the transmission case. Tighten the bolt to 9 N.m (80 in.lbs.).
Install the wiring connector onto the input speed sensor
Verify the transmission fluid level. Add fluid as necessary.
Lower vehicle.