Rear Transponder

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Rear Transponder

Courtesy of DAIMLERCHRYSLER CORP.

1 - BRACKET

2 - RIVETS

3 - TRANSPONDER

4 - ELECTRICAL CONNECTOR

5 - MOUNTING NUT

Raise and support the vehicle.
Drill out the rivets (2) for the transponder mounting bracket (1). See Fig 1.
Disconnect the electrical connector (3). See Fig 1.

Fig 2: Mounting Nuts
Courtesy of DAIMLERCHRYSLER CORP.

1 - TRANSPONDER

2 - NUTS

3 - BRACKET
Pull the transponder (1) with the bracket down and remove the mounting nuts (2) for the transponder (1). See Fig 2.
Remove the transponder (1) from the bracket (3). See Fig 2.