LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 510 (Tires & Wheels) >> Studs >> Installation

Section 510 (Tires & Wheels): Studs: Installation

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Do not use a hammer to remove wheel studs.
  1. Install new stud into hub flange.
  2. Install three washers onto stud, then install lug nut with the flat side of the nut against the washers.
  3. Tighten lug nut until the stud is pulled into the hub flange. Verify that the stud is properly seated into the flange.
  4. Remove lug nut and washers.
  5. Install the brake rotor, caliper adapter, and caliper, (Refer to BRAKES/HYDRAULIC/MECHANICAL/ROTORS - INSTALLATION) .
  6. Install wheel and tire assembly (Refer to TIRES/WHEELS/WHEELS - STANDARD PROCEDURE) , use new lug nut on stud or studs that were replaced.
  7. Remove support and lower vehicle.
scientia non olet · About LEMON Manuals