LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 509 (Suspension System) >> Rear >> Upper Control Arm >> Installation

Upper Control Arm: Installation

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the upper suspension arm in the frame rail brackets. See Figure.
  2. Install the mounting bolts and tighten to 100 N.m (74 ft. lbs.).
  3. Retighten the heat shield back into place.
  4. Pull the arm down on the differential housing bracket and install the pinch bolt and nut. Tighten the nut to 95 N.m (70 ft. lbs.). See Figure.
  5. Remove the supports and lower the vehicle.
scientia non olet · About LEMON Manuals