Stabilizer Bar: Installation

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.

Position the stabilizer bar over the axle and install the bolts to the lower suspension arm. See Fig 1. Ensure the bar is centered with equal spacing on both sides. Tighten the bolts to 99 N.m (73 ft. lbs.).
Remove support and lower the vehicle.

Fig 1: Stabilizer Bar Mounts

Courtesy of DAIMLERCHRYSLER CORP.

1 - STABILIZER BAR MOUNTING BOLTS

2 - LOWER SUSPENSION ARM