Section 509 (Suspension System): Rear: Spring: Removal
WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
- Raise and support the vehicle. Position a hydraulic jack under the axle to support the axle.
- Remove the shock absorber lower bolt from the axle bracket.
- Lower the hydraulic jack and tilt the axle and remove the coil spring. See Fig 1.
- Remove and inspect the upper and lower spring isolators. See Fig 1.
| 1 - UPPER INSULATOR |
| 2 - JOUNCE BUMPER |
| 3 - COIL SPRING |