LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 509 (Suspension System) >> Rear >> Lower Control Arm >> Removal

Lower Control Arm: Removal

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the vehicle and support the rear axle.
  2. Remove the stabilizer bar retaining bolts from the suspension arm.
  3. Remove the lower suspension arm nut and bolt from the axle bracket. See Fig 1.
    NOTE: When removing the right side suspension arm from the frame rail it will be necessary to pry the exhaust over slightly to allow enough clearance to remove the bolt.
  4. Remove the nut and bolt from the frame rail and remove the lower suspension arm. See Fig 1.
Fig 1: Lower Suspension Arm
GC0025584Courtesy of DAIMLERCHRYSLER CORP.
1 - AXLE BRACKET BOLT
2 - LOWER CONTROL ARM
3 - BODY BRACKET BOLT
scientia non olet · About LEMON Manuals