LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 509 (Suspension System) >> Front >> Upper Control Arm >> Installation >> Installation - Right Side

Installation - Right Side

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the upper control arm to the vehicle.
  2. Install the upper control arm front bolt. Tighten the bolt to 122 N.m (90 ft.lbs.).
  3. Install the upper control arm rear bolt. Tighten the bolt to 122 N.m (90 ft.lbs.).
  4. Install the cruise control servo mounting nuts.
  5. Install the air box (Refer to ENGINE/AIR INTAKE SYSTEM/AIR CLEANER ELEMENT - INSTALLATION) .
  6. Install the upper ball joint nut. Tighten the nut to 81 N.m (60 ft.lbs.).
  7. Install the right side tire and wheel assembly. (Refer to TIRES/WHEELS/WHEELS - STANDARD PROCEDURE) .
  8. Lower the vehicle.
  9. Set the toe and center the steering wheel (Refer to SUSPENSION/WHEEL ALIGNMENT - STANDARD PROCEDURE) .
scientia non olet · About LEMON Manuals