LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 509 (Suspension System) >> Front >> Stabilizer Link >> Installation

Stabilizer Link: Installation

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the stabilizer link. See Figure.
  2. Install the upper stabilizer link bolt and washer at the stabilizer bar. Tighten the bolt to 136 N.m (100 ft.lbs.).
  3. Install the lower stabilizer link bolt and washer at the lower control arm. Tighten the nut to 115 N.m (85 ft.lbs.).
  4. Install the tire and wheel assembly. (Refer to TIRES/WHEELS/WHEELS - STANDARD PROCEDURE) .
scientia non olet · About LEMON Manuals