LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 509 (Suspension System) >> Front >> Stabilizer Bar >> Installation

Stabilizer Bar: Installation

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the stabilizer bar to the vehicle.
  2. Install the stabilizer bar bushing clamps. See Figure. Tighten the nuts to 149 N.m (110 ft.lbs.).
  3. Install the upper stabilizer link bolts and washer at the stabilizer bar. Tighten the bolt to 136 N.m (100 ft.lbs.).
  4. Install the tire and wheel assembly. (Refer to TIRES/WHEELS/WHEELS - STANDARD PROCEDURE) .
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals