LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 509 (Suspension System) >> Front >> Spring >> Installation

Section 509 (Suspension System): Front: Spring: Installation

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the shock to the spring and spring compressor, After the transfer of the necessary parts to the type of repair being done (Insulator, Spring, shock and mount).
  2. Install the shock mounting nut. Tighten the bolt to 41 N.m (30 ft.lbs.).
  3. Loosen the compressed spring.
  4. Remove the shock assembly from the spring compressor.
  5. Install the shock to the vehicle. (Refer to SUSPENSION/FRONT/SHOCK - INSTALLATION) .
  6. Install the tire and wheel assembly. (Refer to TIRES/WHEELS/WHEELS - STANDARD PROCEDURE) .
  7. Remove the support and lower the vehicle.
scientia non olet · About LEMON Manuals