LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 509 (Suspension System) >> Front >> Hub / Bearing >> Removal

Hub / Bearing: Removal

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle.
  2. Remove the tire and wheel assembly.
  3. Remove the caliper adapter (Refer to BRAKES/HYDRAULIC/MECHANICAL/DISC BRAKE CALIPERS - REMOVAL) .
    CAUTION: Never allow the disc brake caliper to hang from the brake hose. Damage to the brake hose will result. Provide a suitable support to hang the caliper securely.
  4. Remove the disc brake rotor (Refer to BRAKES/HYDRAULIC/MECHANICAL/ROTORS - REMOVAL) .
  5. Remove the wheel speed sensor (Refer to BRAKES/ELECTRICAL/FRONT WHEEL SPEED SENSOR - REMOVAL) .
  6. Remove the bracket securing the wheel speed sensor wire.
  7. Remove the axle shaft nut. (if equipped with four wheel drive)
  8. Remove the three mounting bolts for the hub/bearing assembly.
  9. Remove the hub/bearing.
scientia non olet · About LEMON Manuals