LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 509 (Suspension System) >> Front >> Hub / Bearing >> Installation

Hub / Bearing: Installation

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the hub/bearing assembly to the vehicle.
  2. Install the three mounting bolts for the hub/bearing. Tighten the bolt to 130 N.m (96 ft.lbs.).
  3. Install the axle shaft nut. Tighten the nut to 135 N.m (100 ft.lbs.). (if equipped with four wheel drive)
  4. Install the bracket to the wheel speed sensor wire.
  5. Install the wheel speed sensor to the hub. Tighten the bolt to 13.5 N.m (10 ft.lbs.) (Refer to BRAKES/ELECTRICAL/FRONT WHEEL SPEED SENSOR - INSTALLATION) .
  6. Install the disc brake rotor (Refer to BRAKES/HYDRAULIC/MECHANICAL/ROTORS - INSTALLATION) .
  7. Install the disc brake caliper adapter. Tighten the nut to 135 N.m (100 ft.lbs.) (Refer to BRAKES/HYDRAULIC/MECHANICAL/ROTORS - INSTALLATION) .
  8. Install the tire and wheel assembly. (Refer to TIRES/WHEELS/WHEELS - STANDARD PROCEDURE) .
scientia non olet · About LEMON Manuals