Rear Fascia: Removal
WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - SWING GATE OPENING |
| 2 - RIVETS (2) |
| 3 - PUSH PIN FASTENERS |
| 4 - REAR FASCIA |
| 5 - SCREWS (4) |
- Remove the wheel flares (rear). (Refer to BODY/EXTERIOR/REAR WHEEL OPENING FLARE MOLDINGS - REMOVAL)
- Remove the rear lamp units. (Refer to ELECTRICAL/LAMPS/LIGHTING - EXTERIOR/REAR LAMP UNIT - REMOVAL)
- Remove the four side bolts. See Fig 1.
- Remove the two bottom rivets.
- Remove the 3 screws along the upper edge.
- Separate the side plastic retainers and remove the fascia from the vehicle.