Rear Fascia: Installation
WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Fascia must be pushed completely forward to allow the plastic retainers full engagement in their respective slots.
- Install the fascia and insert the plastic retainers. See Figure.
- Install the three upper screws.
- Install the four side bolts.
- Install two bottom rivets.
- Install the rear lamp units. (Refer to ELECTRICAL/LAMPS/LIGHTING - EXTERIOR/REAR LAMP UNIT - INSTALLATION)
- Install the rear half wheel opening flares. (Refer to BODY/EXTERIOR/WHEEL OPENING FLARE MOLDING - INSTALLATION)