LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 508 (Frames & Bumpers) >> Front Fascia >> Installation

Front Fascia: Installation

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the fascia onto the vehicle and align the center pin into the hole located near the center of the grille opening reinforcement. See Figure.
  2. Secure the three tabs onto the grille reinforcement fully.
  3. Install the two screws next to the turn signal lamps.
  4. Install the two lower screws.
  5. Install new rivets attaching the wheelhouse splash shield to the fascia.
  6. Install the turn signal lamps. (Refer to ELECTRICAL/LAMPS/LIGHTING - EXTERIOR/PARK/TURN SIGNAL LAMP - INSTALLATION)
  7. Install the grille. (Refer to BODY/EXTERIOR/GRILLE - INSTALLATION)
scientia non olet · About LEMON Manuals