LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 506 (Rack & Pinion Power Steering System) >> Pump >> Hoses >> Removal >> Pressure Hose

Pressure Hose

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Siphon the power steering fluid from the reservoir.
  2. Remove the radiator crossmember (Refer to BODY/EXTERIOR/RADIATOR CROSSMEMBER - REMOVAL) .
  3. Remove the fan (Refer to COOLING/ENGINE/RADIATOR FAN - REMOVAL) .
  4. Remove the fan shroud.
  5. Remove the serpentine belt (Refer to COOLING/ACCESSORY DRIVE/DRIVE BELTS - REMOVAL) .
    Fig 1: Return & Pressure Hose
    GC0025259Courtesy of DAIMLERCHRYSLER CORP.
    1 - RETURN HOSE
    2 - HIGH PRESSURE HOSE
    3 - POWER STEERING PUMP
  6. Remove the pressure hose (2) at the pump (3). See Fig 1.
    Fig 2: Mounting Bracket
    GC0025258Courtesy of DAIMLERCHRYSLER CORP.
    1 - HIGH PRESSURE POWER STEERING HOSE
    2 - MOUNTING BRACKET
  7. Disconnect the pressure switch electrical connector from the pressure hose 2.4L only  .
  8. Remove the pressure hose from the gear.
  9. Remove the pressure hose (1) mounting bracket bolts (2) from behind the headlamp assembly. See Fig 2
  10. Remove the pressure hose (1) from the vehicle and transfer power steering pressure switch if necessary.
scientia non olet · About LEMON Manuals