LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 505 (Exhaust System & Turbocharger) >> Catalytic Converter >> Removal >> 2.4L Engine

2.4L Engine

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: 2.4L Catalyst Assembly - 4X4
GC0025209Courtesy of DAIMLERCHRYSLER CORP.
1- FLANGED NUT
2- CATALYST ASSEMBLY
3- BOLT
4- HANGER
WARNING: IF TORCHES ARE USED WHEN WORKING ON THE EXHAUST SYSTEM, DO NOT ALLOW THE FLAME NEAR THE FUEL LINES.
  1. Raise and support the vehicle.
  2. Saturate the bolts and nuts with heat valve lubricant. Allow 5 minutes for penetration.
  3. Disconnect oxygen sensor electrical connector.
  4. Remove the bolts from the front exhaust pipe/catalytic converter assembly to muffler flange. See Fig 1
  5. Remove bolts and flanged nuts at the manifold.
  6. Lower the catalyst assembly and slide out of the mount at the transmission (if equipped).
  7. Remove the front exhaust pipe/catalytic converter assembly from the vehicle.
scientia non olet · About LEMON Manuals