LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 504 (Body - Interior & Exterior) >> Swing Gate >> Stabilizer Wedge/Insert >> Adjustments >> Adjustment

Stabilizer Wedge/Insert: Adjustments: Adjustment

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Adjust the insert up/down to that it is centered within the stabilizer cup.
  2. Adjust the insert for/aft so the swing gate is 1.0 mm over flush to the d-pillar when the insert contacts the rubber bumper in the stabilizer cup.
  3. Open the swing gate and tighten the bolts to 9 N.m (80 in. lbs.).
    NOTE: Make sure the stabilizer cup and insert are parallel to each other and not twisted.
  4. Close the swing gate and grab the beltline. Confirm minimal for/aft movement and that closing effort is not excessive. Readjust as required.
scientia non olet · About LEMON Manuals