LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 504 (Body - Interior & Exterior) >> Swing Gate >> Flip-Up Glass >> Installation

Flip-Up Glass: Installation

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the flip-up glass, pushing it as far up as it can go and loosely install the hinge bolts.
  2. Adjust flip-up glass fit if necessary, making sure there are equal gaps on both sides of the glass while pushing up on the glass and tighten the hinge bolts to 7 N.m (60 in. lbs.). (Refer to BODY/SWING GATE/FLIP-UP GLASS - ADJUSTMENTS) .
  3. Install the support cylinders. (Refer to BODY/SWING GATE/FLIP-UP GLASS SUPPORT CYLINDER - INSTALLATION) .
  4. Connect the electrical connectors.
scientia non olet · About LEMON Manuals