LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 504 (Body - Interior & Exterior) >> Swing Gate >> Flip-Up Glass - Hinge >> Installation

Flip-Up Glass - Hinge: Installation

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Inspect the hinge cover retention tabs. If they are damaged or cracked, discard the cover and replace with a new one.
  1. Install the hinge onto the vehicle and align with marks made previously.
  2. Install the hinge to glass bolt and tighten to 10 N.m (90 in. lbs.).
  3. Install the bolts and tighten to 7 N.m (60 in. lbs.).
  4. Adjust the flip-up glass as necessary. (Refer to BODY/SWING GATE/FLIP-UP GLASS - ADJUSTMENTS) .
  5. Install the support cylinders. (Refer to BODY/SWING GATE/FLIP-UP GLASS SUPPORT CYLINDER - INSTALLATION) .
  6. Position the top of the hinge cover over the hinge and engage the cover tab. See Figure.
  7. Rock the hinge cover down over the hinge and seat fully. Ensure both lower tabs snap into place.
scientia non olet · About LEMON Manuals