Quarter Window: Installation
WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Open a window before installing glass. This will avoid pressurizing the passenger compartment. If a door or swing gate flip-up glass is slammed before urethane is cured, water leaks can result.
The window opening fence should be cleaned of old urethane bonding material.
- Install the headliner as necessary. (Refer to BODY/INTERIOR/HEADLINER - INSTALLATION) .
- Clean inside of glass with Mopar Glass Cleaner and lint-free cloth.
- Apply PVC (vinyl) primer 25 mm (1 in.) wide around edge of glass. Wipe with clean/dry lint-free cloth.
- Apply fence primer around edge of fence. Allow at least eighteen minutes drying time.
- Apply a 10 mm (0.4 in.) bead of urethane around window vinyl border location.
- Position glass into window opening and lock clips into place.