LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 504 (Body - Interior & Exterior) >> Seats >> Seat - Rear >> Installation

Seat - Rear: Installation

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the seat assembly and position over the studs.
  2. Open the seat back and engage the latches onto the latch strikers.
  3. Install the rear outboard nuts and tighten to 43 N.m (32 ft. lbs.).
  4. Install the outer seat belt anchors. (Refer to ELECTRICAL/RESTRAINTS/SEAT BELT & RETRACTOR - INSTALLATION) .
  5. Install the inner seat belt buckles. (Refer to ELECTRICAL/RESTRAINTS/SEAT BELT BUCKLE - INSTALLATION) .
  6. Install the center seat belt anchor. (Refer to ELECTRICAL/RESTRAINTS/SEAT BELT & RETRACTOR - INSTALLATION) .
  7. Install the front outer seat cushion leg bolts and tighten to 35 N.m (26 ft. lbs.)
scientia non olet · About LEMON Manuals