LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 504 (Body - Interior & Exterior) >> Hood >> Latch >> Installation

Section 504 (Body - Interior & Exterior): Hood: Latch: Installation

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Route latch cable through the hole in the support bracket.
  2. Connect the release cable and install the latch onto the support bracket.
  3. Install the two nuts and tighten to 12 N.m (9 ft. lbs.).
  4. Position the grille opening reinforcement back and install the three upper bolts.
  5. Tighten the bolts to 10 N.m (85 in. lbs.).
scientia non olet · About LEMON Manuals