LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 504 (Body - Interior & Exterior) >> Exterior >> Exterior Name Plates >> Removal

Exterior Name Plates: Removal

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Exterior nameplates are attached to body panels with adhesive tape.
  1. Apply a length of masking tape on the body, parallel to the top edge of the nameplate to use as a guide, if necessary.
  2. If temperature is below 21°C (70°F) warm emblem with a heat lamp or gun. Do not exceed 52°C (120°F) when heating emblem.
  3. Using a trim stick C-4755 or equivalent, behind the emblem to separate the adhesive backing from the body.
  4. Clean adhesive residue from body with MOPAR Super Clean solvent or equivalent.
scientia non olet · About LEMON Manuals