LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 502 (2.8L Diesel Engine (Service Information)) >> Right Mount >> Installation

Right Mount: Installation

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: RIGHT ENGINE MOUNT
GC0026218Courtesy of DAIMLERCHRYSLER CORP.
1 - RIGHT ENGINE MOUNT BRACKET
2 - RIGHT ENGINE MOUNT
  1. Position the engine mount and hand tighten the engine mount bracket bolts. Tighten bolts to 60 N.m (44 lbs. ft.). See Fig 1.
  2. Lower the vehicle and tighten the upper engine mount fastener to 110 N.m (82 ft. lbs.).
  3. Raise the engine.
  4. Tighten the engine mount bracket bolts to 60 N.m (44 lbs. ft.), starting with the right upper then left upper bolt, continuing to the right lower and finishing with the left lower bolt. See Fig 1.
  5. Tighten the engine mount lower fastener to 110 N.m (82 ft. lbs.).
  6. Lower the vehicle.
  7. Install the cooling fan and shroud (Refer to COOLING/ENGINE/RADIATOR FAN - INSTALLATION) .
  8. Connect the negative battery cable.
scientia non olet · About LEMON Manuals