Oil Pressure Sending Unit: Removal

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: SKID PLATE

Courtesy of DAIMLERCHRYSLER CORP.

1 - SKID PLATE

2 - BOLTS (4)

Disconnect the negative battery cable.
Raise and support the vehicle.

Remove the front skid plate. See Fig 1.

Fig 2: OIL SENDING UNIT

Courtesy of DAIMLERCHRYSLER CORP.

1 - OIL PAN GASKET

2 - OIL PAN

3 - OIL SENDING UNIT

4 - OIL FILTER

Disconnect the sending unit electrical connector.
Place an oil drain under the sending unit and unscrew. See Fig 2.