Left Mount: Removal

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: LEFT ENGINE MOUNT

Courtesy of DAIMLERCHRYSLER CORP.

1 - EGR TUBE

2 - STARTER

3 - LEFT ENGINE MOUNT

Disconnect the negative battery cable.
Remove the cooling fan and fan shroud (Refer to COOLING/ENGINE/RADIATOR FAN - REMOVAL) .
Raise and support the vehicle.
Loosen both engine mount through bolts.
NOTE: Care must be taken not to damage any wiring above the transmission when raising the engine.
Using a suitable jack, raise and support the engine.
Remove the engine mount retaining bolts and remove the mount. See Fig 1.