Left Mount: Installation
WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - EGR TUBE |
| 2 - STARTER |
| 3 - LEFT ENGINE MOUNT |
- Position the engine mount and hand tighten the retaining bolts. See Fig 1.
- Lower the engine mount and through bolts into the engine mount support.
- Lower the vehicle.
- Install the left upper engine mount bolt. Tighten bolt to 110 N.m (82 lbs. ft.). See Fig 1.
- Raise and support the vehicle.
- Tighten remaining mount to engine bolts to 60 N.m (44 lbs. ft.) starting with the left upper bolt and continuing clockwise. See Fig 1.
- Tighten engine mount through bolts to 110 N.m (82 lbs. ft.). See Fig 1.
- Lower the vehicle.
- Install the cooling fan and shroud (Refer to COOLING/ENGINE/RADIATOR FAN - INSTALLATION) .
- Connect the negative battery cable.