LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 502 (2.8L Diesel Engine (Service Information)) >> Air Cleaner Housing >> Removal

Air Cleaner Housing: Removal

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: AIR CLEANER HOUSING
GC0025229Courtesy of DAIMLERCHRYSLER CORP.
1 - AIR CLEANER HOUSING
2 - INLET DUCT
  1. Disconnect the mass airflow connector.
  2. Remove the air outlet hose from the air cleaner assembly.
  3. Pry up two spring clips from front of housing cover (spring clips retain cover to housing).
  4. Release housing cover from locating tabs located on rear of housing, and remove cover.
  5. Remove the air cleaner element.
  6. Remove the air inlet duct.
  7. Pulling upward, remove the air cleaner housing from the rubber mounts. See Fig 1.
scientia non olet · About LEMON Manuals