Engine - 3.7L: Specifications: Torque
WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
| DESCRIPTION | N.m | Ft. | In. |
|---|---|---|---|
| - | Lbs. | Lbs. | |
| Camshaft | - | - | - |
| Non - Oiled Sprocket Bolt | 122 | 90 | - |
| Bearing Cap Bolts | 11 | - | 100 |
| Counterbalance shaft retaining bolt | 28 | - | 250 |
| Timing Chain Cover-Bolts | 58 | 43 | - |
| Connecting Rod Cap-Bolts | 27 | 20 | - |
| PLUS 90° TURN | |||
| Bed Plate-Bolts | Refer to Procedure | ||
| Crankshaft Damper-Bolt | 175 | 130 | - |
| Cylinder Head-Bolts | |||
| M11 Bolts | Refer To Procedure | ||
| M8 Bolts | Refer To Procedure | ||
| Cylinder Head Cover-Bolts | 12 | - | 105 |
| Exhaust Manifold-Bolts | 25 | 18 | - |
| Exhaust Manifold Heat Shield-Nuts | 8 | - | 72 |
| Then loosen 45° | |||
| Flexplate-Bolts | 95 | 70 | - |
| Engine Mount Bracket to Block-Bolts | 61 | 45 | - |
| Rear Mount to Transmission-Bolts | 46 | 34 | - |
| Generator Mounting-Bolts | |||
| M10 Bolts | 54 | 40 | - |
| M8 Bolts | 28 | - | 250 |
| Intake Manifold-Bolts | 12 | - | 105 |
| Refer to Procedure for | |||
| Tightening Sequence | |||
| Oil Pan-Bolts | 15 | - | 130 |
| Oil Pan-Drain Plug | 34 | 25 | - |
| Oil Pump-Bolts | 28 | - | 250 |
| Oil Pump Cover-Bolts | 12 | - | 105 |
| Oil Pickup Tube-Bolt and Nut | 28 | - | 250 |
| Oil Dipstick Tube to Engine | - | - | - |
| Block-Bolt | 15 | - | 130 |
| Oil Fill Tube-Bolts | 12 | - | 105 |
| Timing Chain Guide-Bolts | 28 | - | 250 |
| Timing Chain Tensioner Arm-Bolt | 28 | - | 250 |
| Hydraulic Tensioner-Bolts | 28 | - | 250 |
| Timing Chain Primary Tensioner-Bolts | 28 | - | 250 |
| Timing Drive Idler Sprocket-Bolt | 34 | 25 | - |
| Thermostat Housing-Bolts | 12 | - | 105 |
| Water Pump-Bolts | 24 | 18 | - |