LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 501 (3.7L Engine (Service Information)) >> Idler Shaft >> Removal

Idler Shaft: Removal

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the primary and secondary timing chains and sprockets. Refer to procedure in this article.
    NOTE: To remove the idler shaft, it is necessary to tap threads into the shaft, to install the removal tool.
  2. Using a 12 mm X 1.75 tap, cut threads in the idler shaft center bore.
  3. Cover the radiator core with a suitable cover.
    CAUTION: Use care when removing the idler shaft, Do not strike the radiator cooling fins with the slide hammer.
  4. Using Special Tool 8517 Slide Hammer, remove the idler shaft.
scientia non olet · About LEMON Manuals