LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 500 (2.4L Engine (Service Information)) >> Valve Springs >> Removal >> Removal - Cylinder Head On

Removal - Cylinder Head On

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove camshafts.
  2. Rotate crankshaft until piston is at TDC on compression.
  3. With air hose attached to adapter tool installed in spark plug hole, apply 90-120 psi air pressure.
  4. Using Special Tool MD-998772-A with adapter 6779, compress valve springs and remove valve locks. See Fig 1.
  5. Remove valve spring(s).
  6. Remove valve stem seal(s) by a using valve stem seal tool. See Figure.
Fig 1: Valve Spring - Removal/Installation
GC0021206Courtesy of DAIMLERCHRYSLER CORP.
1 - VALVE SPRING COMPRESSOR MD 998772A
2 - AIR HOSE
scientia non olet · About LEMON Manuals