LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 500 (2.4L Engine (Service Information)) >> Timing Belt TENSIONER & Pulley >> Installation

Timing Belt TENSIONER & Pulley: Installation

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Align timing belt tensioner assembly to engine and install lower mounting bolt but do not tighten  . To properly align tensioner assembly-install one of the engine bracket mounting bolts (M10) 5 to 7 turns into the tensioner's upper mounting location.
  2. Torque the tensioner's lower mounting bolt to 61 N.m (45 ft. lbs.). Remove the upper bolt used for tensioner alignment.
  3. Install rear timing belt cover and fasteners.
  4. Install timing belt idler pulley and torque mounting bolt to 61 N.m (45 ft. lbs.).
  5. Install camshaft sprockets. Use Special Tool 6847 to hold sprockets, torque bolts to 101 N.m (75 ft. lbs.).
  6. Install the timing belt. (Refer to ENGINE/VALVE TIMING/TIMING BELT/CHAIN AND SPROCKETS - INSTALLATION) 
scientia non olet · About LEMON Manuals