LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 500 (2.4L Engine (Service Information)) >> Oil Pan >> Removal

Oil Pan: Removal

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove air cleaner assembly.
  2. Raise vehicle on hoist and drain engine oil.
  3. Loosen the engine mount thru bolts.
  4. Disconnect exhaust pipe at manifold.
  5. Remove structural collar, if equipped.
  6. Remove front axle mounting bolts, and lower axle as far possible, if equipped.
  7. Position Special Tool 8534 on fender lip and align the slots in the brackets with the fender mounting holes.
  8. Secure brackets to the fender using four M6 X 1.0 X 25 MM flanged cap screws.
  9. Tighten the thumbscrews to secure the sleeves to the support tube.
  10. Secure the support tube in an upright position.
  11. Assemble the flat washer, thrust bearing, hook and T handle.
  12. Using the M10 X 1.5 X 40 mm capscrew supplied with the support fixture, secure the chain to the front cover and the hook.
  13. Support engine as needed.
  14. Remove oil pan attaching bolts.
  15. Remove oil pan.
  16. Clean oil pan and all gasket surfaces.
scientia non olet · About LEMON Manuals