HCU (Hydraulic Control Unit): Removal
WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - ABM MODULE |
| 2 - ABM MODULE MOUNTING SCREWS |
| 3 - ABM UNIT |
| 4 - ELECTRICAL CONNECTOR |
| 5 - MOUNTING BRACKET |
- Install prop rod on the brake pedal to keep pressure on the brake system.
- Remove negative battery cable from the battery.
- Pull up on the ABM harness connector release (4) and remove connector. See Fig 1.
1 - BRAKE LINES 2 - ABM UNIT 3 - MOUNTING NUTS - Remove brake lines (1) from the ABM (2).
- Remove ABM (2) mounting nuts (3) and remove ABM(2). See Fig 2.