LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 498 (Mechanical Brake System - Base (Service Information)) >> Brakes - Base >> Power Brake Booster >> Removal >> Right Hand Drive (RHD)

Right Hand Drive (RHD)

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the air box (Refer to ENGINE/AIR INTAKE SYSTEM/AIR CLEANER ELEMENT - REMOVAL) .
  2. Relocate the cruise control servo to gain access to the booster for removal.
  3. Remove the brake lines from the master cylinder.
  4. Remove the master cylinder (Refer to BRAKES/HYDRAULIC/MECHANICAL/MASTER CYLINDER - REMOVAL) .
  5. Disconnect vacuum hose from booster check valve.
  6. Remove knee blocker under the steering column, (Refer to BODY/INSTRUMENT PANEL/KNEE BLOCKER - REMOVAL) .
    Fig 1: Booster Push Rod
    GC0025494Courtesy of DAIMLERCHRYSLER CORP.
    1 - BRAKE PEDAL
    2 - BOOSTER ROD
  7. Remove the brake light switch, (Refer to ELECTRICAL/LAMPS/LIGHTING - EXTERIOR/BRAKE LAMP SWITCH - REMOVAL)
  8. Remove retaining clip that secures booster push rod (2) to brake pedal (1). See Fig 1.
    Fig 2: Booster Mounting
    GC0025493Courtesy of DAIMLERCHRYSLER CORP.
    1 - BRAKE BOOSTER
  9. Remove nuts attaching booster (1) to the dash panel. See Fig 2.
  10. In engine compartment, slide booster studs out of dash panel, tilt booster upward, and remove booster from engine compartment.
scientia non olet · About LEMON Manuals