LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 498 (Mechanical Brake System - Base (Service Information)) >> Brakes - Base >> Fluid Reservoir >> Removal

Fluid Reservoir: Removal

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install prop rod on brake pedal to keep pressure on the brake system.
  2. Remove reservoir cap and siphon fluid into drain container.
  3. Remove the electrical connector from the fluid level switch in the reservoir.
  4. Remove the reservoir mounting bolt.
  5. Remove the reservoir from the master cylinder by pulling upwards.
  6. Remove old grommets from cylinder body.
scientia non olet · About LEMON Manuals