LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 498 (Mechanical Brake System - Base (Service Information)) >> Brakes - Base >> Fluid Reservoir >> Installation

Fluid Reservoir: Installation

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Fill and bleed master cylinder on bench before installation in vehicle.
    CAUTION: Do not use any type of tool to install the grommets. Tools may cut, or tear the grommets creating a leak problem after installation. Install the grommets using finger pressure only.
  2. Lubricate new grommets with clean brake fluid and Install new grommets in cylinder body. Use finger pressure to install and seat grommets.
  3. Start reservoir in grommets. Then rock reservoir back and forth while pressing downward to seat it in grommets.
  4. Install the mounting bolt for the reservoir to the master cylinder.
  5. Reconnect the electrical connector to the fluid reservoir level switch.
  6. Remove the prop rod from the vehicle.
  7. Fill and bleed base brake system, (Refer to BRAKES - STANDARD PROCEDURE) .
scientia non olet · About LEMON Manuals